Furnace Repair and Air Conditioner Repair in Kentwood MI

Completed full system replacement of existing 90% efficiency furnace with new Signature Elite furnace and matching air conditioning system. Installed 35-foot refrigerant line set connecting outdoor condensing unit to indoor evaporator coil. Replaced ductwork and venting components up to the point where existing runs transition over finished ceiling areas. Integrated new filter cabinet, thermostat, and 24-volt control wiring to ensure proper system operation and communication between all HVAC components.

Completed full HVAC system installation in main floor condo unit, including 80% efficiency Merit furnace and matching air conditioning system. Mounted furnace on filter cabinet base with central return configuration, installed 20-foot refrigerant line set connecting outdoor condensing unit to indoor evaporator coil, and commissioned complete system for operation.

Installed complete chimney liner system including flexible stainless steel flue liner, termination cap, mounting flange, and securing collars. All components were properly fitted and secured to ensure safe venting operation and code compliance.

Completed full system installation replacing existing 17.5" wide 80% efficiency furnace and legacy air conditioning unit with new equipment. Installed new floor drain pan beneath furnace, reused existing media cabinet and refrigerant line set to minimize modifications. Added flush kit to system and ran 20 feet of 3/4" PVC condensate line along with 40 feet of 2" PVC venting for proper drainage and exhaust. Prioritized air conditioning system startup and testing before proceeding with heating system commissioning per service requirements. Verified all electrical connections including new disconnect box, confirmed proper drainage through new pan, and ensured both heating and cooling systems operational upon completion. Gold Choice warranty coverage activated for installation.

Removed existing flexible dryer vent line and replaced with new rigid metal dryer vent ductwork. Extracted old insulation and debris from previous installation, disposing of materials properly on-site. System now meets current code requirements for proper dryer venting with improved airflow and reduced fire hazard.

Completed air conditioner installation on existing furnace system with 17.5" width clearance and raised uncased coil configuration. Installed 5-10 ft refrigerant lineset and ran 10 ft of 3/4" PVC condensate drain line. System tested and verified operational with all electrical connections secured using appropriate fusing.

Completed air conditioner installation utilizing a 20-foot refrigerant line set routed from the outdoor unit behind the furnace to the indoor air handler. Installed new electrical disconnect with 250VAC fuse protection and ran dedicated circuit to the breaker panel per code requirements. System was charged, tested, and verified operational with all safety controls functioning properly.

Completed full HVAC system installation including furnace and air conditioning unit with humidifier, cabinet, drain, condensate pump, and Green Choice upgrade. Installed 50 ft refrigerant line set and 30 ft venting system, rerouting the line set along the exterior wall to avoid obstruction in living space. System tested and operational upon completion.

Completed installation of Merit AC gas furnace with filter cabinet drop. Utilized existing 3" penetrations in front of furnace from previous tankless water heater installation for venting, installing approximately 15 feet of PVC venting material. Verified and secured basement return air ductwork that was previously detached, ensuring proper system airflow. Condensate pump was retained as existing equipment per specifications.

Installed new air conditioning system with 40-foot refrigerant line set connected to existing Evolution furnace with 21-inch cased coil. Performed system flush, replaced condensate drain line and trap, installed new 250V fuse, and utilized existing condensate pump and GFI outlet to complete installation.